09-07-2023, 11:07 AM
Hi, being new to relay boards I have a few questions I need cleared up.
1. I am running a fully 12V lithium battery system with an inverter for 240v devices. Can I mix and match relay output voltages (12v and 240v)? See image.
![[Image: Kincony.png]](https://i.ibb.co/sWxjnx9/Kincony.png)
2. I watched this video https://www.youtube.com/watch?v=xptAHlOLV-w. In the comments you stated the A4 board can only run one digital led strip. Can this A8 run two digital strips, one from S3 and another from S4?
3. If I buy two of these, can they run independantly (different yaml files), or do I have to connect them to avoid conflicts?
4. I have limited space to install this. What are the dimensions of this board with the case attached,
5. Can I buy the case on its own rather than in the bundle offered?
6. You have probably listed it elsewhere, but can you give me some examples of what can go in the analogue inputs.
Thanks.
1. I am running a fully 12V lithium battery system with an inverter for 240v devices. Can I mix and match relay output voltages (12v and 240v)? See image.
2. I watched this video https://www.youtube.com/watch?v=xptAHlOLV-w. In the comments you stated the A4 board can only run one digital led strip. Can this A8 run two digital strips, one from S3 and another from S4?
3. If I buy two of these, can they run independantly (different yaml files), or do I have to connect them to avoid conflicts?
4. I have limited space to install this. What are the dimensions of this board with the case attached,
5. Can I buy the case on its own rather than in the bundle offered?
6. You have probably listed it elsewhere, but can you give me some examples of what can go in the analogue inputs.
Thanks.