09-13-2023, 08:07 AM
(08-17-2023, 03:32 PM)hentes Wrote: Hello.
Anybody else having issues to read meter (KC868-Meter-1PV-RS485) data with KC868-COLB using Kincony Smart Board controller software?
Steps taken:
1. connected the Meter to COLB. Wire B to 12, wire A to 11
2. no other sensors or devices are connected to COLB, only the meter
3. successfully connected to COLB with Kincony SCB_V1.0.410.504
4. Enabled Autoreport
5. Opened the EMeter page
6. Set meter ID number
7. Clicked the Read button
After waiting about 1 minute all fields (kWH, V, A, kW, Q, Hz) are still 0.
Changed the meter to another one (replaced the meter ID in Kincony SCB_V1.0.410.504 ) but the result is the same. Cannot read meter data.
Any help will be appreciated. Thank you.
the address of your Meter is 204 print on the side .you should set the address on the software