automation not working properly with KCS V2.1.2

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

automation not working properly with KCS V2.1.2

admin Offline

Offline

Administrator

Posts: 6,325
Threads: 808
Joined: Oct 2020
Reputation: 155

#4

09-19-2023, 12:04 PM (This post was last modified: 09-19-2023, 12:07 PM by admin.)

PC connect to board by USB cable. open serial tool is ok.

Filename: debug.png Size: 75.49 KB 09-19-2023, 12:07 PM

YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

automation not working properly with KCS V2.1.2 - by engmohades - 09-19-2023, 05:39 AM

RE: automation not working properly with KCS V2.1.2 - by admin - 09-19-2023, 11:50 AM

RE: automation not working properly with KCS V2.1.2 - by engmohades - 09-19-2023, 11:55 AM

RE: automation not working properly with KCS V2.1.2 - by admin - 09-19-2023, 12:04 PM

RE: automation not working properly with KCS V2.1.2 - by engmohades - 09-19-2023, 04:04 PM

RE: automation not working properly with KCS V2.1.2 - by engmohades - 09-19-2023, 06:13 PM

RE: automation not working properly with KCS V2.1.2 - by admin - 09-19-2023, 10:17 PM

RE: automation not working properly with KCS V2.1.2 - by engmohades - 09-20-2023, 04:52 AM

RE: automation not working properly with KCS V2.1.2 - by KinCony Support - 09-20-2023, 08:29 AM

RE: automation not working properly with KCS V2.1.2 - by KinCony Support - 09-20-2023, 08:40 AM

RE: automation not working properly with KCS V2.1.2 - by admin - 09-20-2023, 06:24 AM

View a Printable Version

Forum Jump:

Users browsing this thread:

1 Guest(s)