11-18-2023, 10:29 PM
I'm testing my new KC868-M16-v2.
Using clamps YHDC 30A->1V.
I did the calibration without load and with a load of about 1kW at 220V.
When I measure without any current, the reading fluctuates around 0.
When I measure with the load working, I get the value also fluctuating around the setting I entered through calibation.
I use a coffe machine as this load of around 1kW.
While I do the reading with the M16v2, I simultaneously read the current using a Shelly Pro 1PM, which shows me a rock steady current during the test.
Are there known reasons why this phenomenon may happen?
Can I address it by changing anything in the configuration?
Thanks in advance
Using clamps YHDC 30A->1V.
I did the calibration without load and with a load of about 1kW at 220V.
When I measure without any current, the reading fluctuates around 0.
When I measure with the load working, I get the value also fluctuating around the setting I entered through calibation.
I use a coffe machine as this load of around 1kW.
While I do the reading with the M16v2, I simultaneously read the current using a Shelly Pro 1PM, which shows me a rock steady current during the test.
Are there known reasons why this phenomenon may happen?
Can I address it by changing anything in the configuration?
Thanks in advance