Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A16 flash problem
#18
(11-21-2023, 11:46 PM)admin Wrote: 1. Do you have connected DC12v power supply for KC868-A16?
2. if you installed RF433M module, please remove it when download firmware.
take a photo of your board, how you wire.

Good morning. After removing the RF modul, the program recorded. I'll try to record skits later.


Attached Files Image(s)
   
Reply


Messages In This Thread
A16 flash problem - by saint_code - 07-09-2023, 12:50 PM
RE: A16 flash problem - by admin - 07-09-2023, 11:25 PM
RE: A16 flash problem - by saint_code - 07-10-2023, 09:00 AM
RE: A16 flash problem - by admin - 07-10-2023, 11:34 AM
RE: A16 flash problem - by saint_code - 07-10-2023, 12:04 PM
RE: A16 flash problem - by admin - 07-10-2023, 12:29 PM
RE: A16 flash problem - by saint_code - 07-22-2023, 09:49 AM
RE: A16 flash problem - by saint_code - 07-22-2023, 11:14 AM
RE: A16 flash problem - by admin - 07-22-2023, 12:00 PM
RE: A16 flash problem - by zeltini1401 - 11-20-2023, 07:34 AM
RE: A16 flash problem - by admin - 11-20-2023, 10:46 AM
RE: A16 flash problem - by zeltini1401 - 11-20-2023, 03:54 PM
RE: A16 flash problem - by admin - 11-20-2023, 10:30 PM
RE: A16 flash problem - by zeltini1401 - 11-21-2023, 06:01 AM
RE: A16 flash problem - by admin - 11-21-2023, 10:18 AM
RE: A16 flash problem - by zeltini1401 - 11-21-2023, 03:53 PM
RE: A16 flash problem - by admin - 11-21-2023, 11:46 PM
RE: A16 flash problem - by zeltini1401 - 11-22-2023, 06:09 AM
RE: A16 flash problem - by admin - 11-22-2023, 09:51 AM
RE: A16 flash problem - by zeltini1401 - 11-25-2023, 04:52 PM
RE: A16 flash problem - by admin - 11-25-2023, 11:13 PM
RE: A16 flash problem - by zeltini1401 - 11-26-2023, 08:56 AM
RE: A16 flash problem - by admin - 11-26-2023, 11:21 AM
RE: A16 flash problem - by zeltini1401 - 11-27-2023, 10:31 AM
RE: A16 flash problem - by admin - 11-27-2023, 10:45 AM
RE: A16 flash problem - by zeltini1401 - 11-29-2023, 12:38 PM
RE: A16 flash problem - by admin - 11-29-2023, 11:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)