MQTT connect but no data

[papakigr]

Hello, i see that the COLB is connected to the MQTT broker but i don't receive any data.

When i connect to the local pc software i see that the device working (have data).

What should i do?

[bigramon]

Hello, i see that the COLB is connected to the MQTT broker but i don't receive any data.

When i connect to the local pc software i see that the device working (have data).

What should i do?

Hi,

Use MQTT explorer to debug the messages and get a better idea of what is going on.
Messages are published under relay32.

Good luck!

[admin]

you should enable the "AutoReport" function in PC software firstly, then MQTT will have message auto upload.

[papakigr]

Thanks!

[hentes]

Did you managed to resolve your issue? I have the same situation. COLB send only data for digital sensors, not for temperature and analog sensors. Autoreport is  turned on and after COLB restart sends data for a single time, then nothing (only digital sensor values).

[admin]

do you have set the threshold value firstly?

[hentes]

do you have set the threshold value firstly?

That was the problem. Now it's working like a charm. Thank you. 
Did you succeeded to add 1 phase power meter reading with mqtt on COLB device?

[admin]

use Node-Red can read energy meter and feedback to home assistant.

[hentes]

use Node-Red can read energy meter and feedback to home assistant.

Do you have a link to this flow? I'm not really a Node-Red expert 

[admin]

it's not easy. need to write code. i think you can chose some wifi energy meter so that support MQTT directly.