KC868-HA PC software V1.0.5.1011

[admin]

make sure your computer have installed CH340 USB-RS232 driver.
   
   

  HA485_Ctrl_V1.0.5.1011.zip (Size: 912.26 KB / Downloads: 228)

[mart81]

Hi there,

I have two questions:

- Is the PC Software also available for Linux?
- Is it possible to change the Baudrate of the KC868-HA-V2. I have other stuff on my RS485-Bus which needs different Baudrate.

Thanks very much in advance.

[mart81]

Hi there again,

ok, I found out how to change the baudrate.
I changed it to 57600 baud without parity. That worked.

But I need 57600 baud with parity even. It seems that setting parity doesn't work. I tried it with even and odd.
Could you please check that.

My firmware version is V200

Thanks very much in advance.

Martin

[admin]

how do you use HAv2, HAv2 connect to KinCony's relay board? or HAv2 connect to raspberry pi directly?

[mart81]

how do you use HAv2, HAv2 connect to KinCony's relay board? or HAv2 connect to raspberry pi directly?

I connected it to a KC868-AP. But I have other clients on the bus where I cannot change the communication parameters.

Sorry for my late reply. I did not get a notification.

[admin]

KC868-AP not support HA board.

[mart81]

KC868-AP not support HA board.

I already used it with KC868-AP and EspHome. It worked with a slower baudrate.
The only problem I have is that I cannot set the right parity. I think it is a bug in HA firmware.

[admin]

HAv2 support change baudrate by PC software.

[mart81]

HAv2 support change baudrate by PC software

Yes I know. As I said I already did that. But setting parity to anything different than "none" does NOT work. This is why I think there is an error in the firmware of HAv2 or the PC software.

[admin]

do you means, the partity only work for "NONE"?