KC868-H32BS smart controller module released

[admin]

We have designed new smart controller KC868-H32BS. it have 6 digital input ports for sensors, 34 digital input ports for self-reset switch button and 32 P-MOSFET output ports, support use RF 433MHz wireless remoter. Add RS485 Modbus port. Also support MQTT and HTTP command for development.

[papakigr]

looks good, what is: P-MOSFET output ports?

[admin]

The metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET), also known as the metal–oxide–silicon transistor (MOS transistor, or MOS), is a type of insulated-gate field-effect transistor that is fabricated by the controlled oxidation of a semiconductor, typically silicon. The voltage of the covered gate determines the electrical conductivity of the device; this ability to change conductivity with the amount of applied voltage can be used for amplifying or switching electronic signals.

[uvrtar]

Hi,

is it possible with this controller to use it like dimmer D8 - when the dry contact is pressed the mosfet stays on, and when dry contact is relesed the mosfet is off?

Thank you.

[admin]

of course, it can use by dry contact for on and off.

[Sten]

Hi

Is it possible to add the TOGGLE function to the double click mode?

[admin]

yes, it support. here is video guide: https://youtu.be/32tl2SltmnU

[papakigr]

Hello,

can the mosfet give power to LED strip directly?

To give 12v or 24v and connect on the output the plus (+) of the LED strip?

[admin]

it's no problem, but how much amper you will use for LED strip, you should calculate it for chose your extend power supply.

[papakigr]

So if the led strip need for instance 200w and the power supply that i will connect is 300w, it should be ok to pass through the mosfet?

I see on the products parameter that the output load is 12/24v 500mA, that is why i am asking.