[Arduino source code for KC868-A8M]-02 DS18B20

[KinCony Support]

Code:

#include <DS18B20.h>

DS18B20 ds(14);   //IO13

void setup() {
  Serial.begin(115200);
}

void loop() {
 
    Serial.printf("Temperature: %.2f C\n",ds.getTempC());
    delay(1000);
}

[Arduino source code for KC868-A8M]-02 DS18B20

[happyname34]

I was able to get multiple DS18B20 temperature sensors working in esphome. At first I thought it should be GPIO13 but that did not work, 14 did though. Also note that the 4.7kohm resistor is built into the board. 

dallas:
  - pin: GPIO14
    update_interval: 2s

sensor:
  - platform: dallas
    address: 0x254697d446e4b828
    name: "Temperature"

  - platform: dallas
    address: 0x6a570fd4466e1628
    name: "Temperature2"

[admin]

ok, good.