Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
m30 rs485 compatible energy meter
#1
hi, i will purchase a m30
and want to know if a rs485 like this
Just found this amazing item on AliExpress. Check it out! CLP33.582 | 1P Energy Meter RS485 Modbus RTU Monitor Voltage Current Power Factor Frequency Toal Consumption
https://a.aliexpress.com/_mstTztE
its compatible and if the esphome yaml include this comunication
to see all the power di energy in 1 sensor!
Reply
#2
sure, you can integrate to esphome by modbus controller.
Reply
#3
There is any diagram connection ? Thanks a lot. Any special configuration or the m30 just detect the modbus and receive the consume and present as an entity?
I see a config in the yaml

uart:
id: modbus_uart
rx_pin: 32
tx_pin: 33
baud_rate: 115200
stop_bits: 1
data_bits: 8
parity: NONE
Reply
#4
https://www.kincony.com/forum/showthread.php?tid=4089
Reply
#5
thanks. im not an expert. and sorry for ask.. but with this https://shop.kincony.com/products/energy...3321597093 or https://shop.kincony.com/products/energy...3321629861 There is any special config in the yaml in esp home?
Reply
#6
see this video tour: https://youtu.be/1b9_oyCseCE
Reply
#7
Great! but in my case I will use with the M30 and home assistant. Just connect the A and B port in the output of the RS485 to the RS485 ab in the m30? The config and esphome will do the rest? Thanks again!! Im waiting my first kincony product!
Reply
#8
where you home assistant installed? raspberry pi?
Reply
#9
OPtiplex 7070 micro PC, but my idea is to connect to this rs485 with a m30.-

https://es.aliexpress.com/item/400046297...Redirect=y 

80AMP


Attached Files Image(s)
   
Reply
#10
this is modbus energy meter, you can connect to your server's USB-RS485 port directly. or you can conenct to one kincony esp32 board's RS485 port. here is video tour:https://youtu.be/xEvOK3R12kc
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)