Rs485

[Savino]

download KCS firmware to A6 board, enable RS485 using MODBUS-RTU. just login KCS webpage to set.

Sorry, I'm not using KCS firmware for the A6 board.

I flashed the A6 board with a basic yaml file downloaded from ESP Home support pages.

So I only need to add to the yaml file the correct lines in order to:

• enable RS485 using MODBUS-RT,
  
• setting address, baudrate, parity, stopbit and so on...
  

Could you show me the details? Thanks in advance

[admin]

i already sent you video tour link, just do as that .

[Savino]

if you are first time to use server-mini,  you need to enable serial port for CM4, here is details :
https://www.kincony.com/forum/showthread.php?tid=1971

I was able to find the config.txt file on my Sd card and set enable_uart=1 
Unfortunately trying to disable Linux Uart console I go to the homeassistant terminal and when I try the command 

sudo raspi-config 

I get the message command not found.

Any hint for this step?

[admin]

where you installed home assistant software? raspberry pi?
which home assistant firmware you have installed?

[Savino]

where you installed home assistant software? raspberry pi?
which home assistant firmware you have installed?

home assistant installed onto KC868-Server Mini with CM4 and SD card.

the firmware installed was
haos_rpi4-64-7.4.img

At the moment I have
Home Assistant Core 2024.7.0
          Supervisor 2024.06.2
          Operating System 12.4
          Frontend 20240703.0

[admin]

can you take a video of your problem, when you input "sudo raspi-config" have error. send video to whatsapp number: +86-15381188302