07-27-2024, 12:43 AM
it's not easy to change address, you can try to open the sensor, there is a tiny PCB, if you can weld, you can change the i2c address.
A8S and Modbus sensor
|
07-27-2024, 12:43 AM
it's not easy to change address, you can try to open the sensor, there is a tiny PCB, if you can weld, you can change the i2c address.
08-20-2024, 09:54 AM
In your e-shop you write that the address should be editable. So is it?
https://shop.kincony.com/products/rs485-...e-by-sht30
08-20-2024, 12:12 PM
use PC software to config the RS485 address. after click "set" button, then power off the sensor and power on again.
PC software download: Debug.zip (Size: 4.08 MB / Downloads: 25)
08-21-2024, 06:47 AM
Finally, it is working. Thank you very much.
For anyone else trying to set an address without the provided software. You should set the address to registry `0x0a`.
08-21-2024, 07:42 AM
ok, thanks share your result.
|
« Next Oldest | Next Newest »
|
Users browsing this thread: |
1 Guest(s) |