09-18-2024, 12:29 PM
I'm new to this HW, so maybe I'm missing something.
I have a remote 433mhz that I "learned" on the Web UI.
When I transmit the signal, it is being sent around 5 times, triggering the receiving device to turn on and off and on again etc.
Basically, the device (ventilator) beeps when it gets a signal, and I'm hearing around 5 beeps.
Is there any way to configure this behavior?
Or should I flash the device with a different fimware? Can I just flash esphome on it - and hope to fix this somehow that way?
Current firmware: v2.2.4
I have a remote 433mhz that I "learned" on the Web UI.
When I transmit the signal, it is being sent around 5 times, triggering the receiving device to turn on and off and on again etc.
Basically, the device (ventilator) beeps when it gets a signal, and I'm hearing around 5 beeps.
Is there any way to configure this behavior?
Or should I flash the device with a different fimware? Can I just flash esphome on it - and hope to fix this somehow that way?
Current firmware: v2.2.4