KCS firmware

[admin]

Where to connect HC-SR04? It works on 5V and HT ports on 3V.
Maybe it's better to use 433M interface? 433M_T signal as trigger and DATA_R as echo. There is also 5V power supply on connector P2.
How to set PIN parameter?

Yes, HC-SR04 sensor output signal level is 5V or 0V. you can connect with 433MHz receiver data pin on PCB, that is 5v level.

[xxpeta]

Hello,
one suggestion to improve your KCS firmware for KS868-AI:

add a possibility to send status of all inputs via UDP by defined time in setup, i.e. every 5 minutes.

It will help with integration to Loxone system, because now is sent only once by change and may happen, that UDP packet will be lost.

Thanks in advance.
Petr

[admin]

wheher Loxone can decode message with all input state together? or only can update by single channel?
now whether input state changed , will auto upload message. because if alway loop, message will cost resource.

[xxpeta]

wheher Loxone can decode message with all input state together? or only can update by single channel?
now whether input state changed , will auto upload message. because if alway loop, message will cost resource.

Loxone can parse the message  (RELAY-INPUT-255,1,\v ) but it should look like this to be able use the same virtual input:
RELAY-INPUT-255,1,1|RELAY-INPUT-255,2,0|RELAY-INPUT-255,3,1...

Or you can just repeat all single messages in loop. If the repeat interval will be in minutes, there will be small costs of resources.

[admin]

ok, understand.