Energy consumption not measured

[sebastianfs]

Hi,

yesterday I received my M30 board and the installation was straight forward.

Now I have a problem that I can't explain. All 30 current clamp sensors do not measure the energy constumtion (kwh). Voltage, current and power are shown without any issue, but the energy sensors are always 0.00 kWh.

I´m using your yaml template for ESP Home and my goal is to integrate the sensors into the energy dashboard of Home Assistant.

I hope you can help me to solve this issue.

BR
Sebastian

[admin]

take a photo , what's M30 KCS firmware version you are using.
upload your yaml at here.

[sebastianfs]

Please find my yaml attached, but I don´t know how to read the current KCS firmware version.

Can you explain the steps in more detail?

---

It seems that my problem is caused by the inaccuracy of the decimal places of the energy sensors. Because now I have noticed that the value of the energy sensor has changed from 0.00 to 1.00 between 1 and 2 am.

As a result, the entire 1 kWh is suddenly displayed in the energy dashboard, which also leads to a negative deviation.

How can the accuracy of the energy sensors be increased to 1 or better 2 decimal places?