how to install KC868-AG without HA

[ahiel]

I've just got KC868-AG and want to install it to use it with MQTT (I'm using openhab).
how can I configure it?
just connected it to power (see green light). but can't see any new wifi network. 
any manual?

thanks!

[admin]

just download KCS v2 firmware, here is online guide: https://www.kincony.com/esp32-kcsv2-firmware.html

[ahiel]

Thank you!
okay, I see that it is not like tasmota and not listening always to IR.
I saw I can use tasmota by installing (https://tasmota.github.io/install/) and choosing ESP32 and update the configuration (https://templates.blakadder.com/kincony_KC868-AG.html).
Is there a tasmota binary version that support RF for this device?

[admin]

just download tasmota common firmware, define RF sender and RF receiver pin for ESP32.

[ahiel]

Thank you for your reply.

Is the configuration template should be the same as the one in the IR?
I see a comment that "Support for RF requires a custom compiled binary."
I installed tasmota and now I don't see option of RFrecv or RFSend (or buzzer) in the GPIO.
how can I make it work?
do I need to change the template? or the one above is okay?

Thanks

[admin]

When compiling your build add the following to user_config_override.h, here is details: https://tasmota.github.io/docs/RF-Protocol/
so need compile a new tasmota firmware.