01-30-2025, 12:47 PM
Not sure where to report this, but three bugs I've found with the KCS firmware, latest version (v2.2.8).
- The LAN activity LED (green) flickers constantly even though there's no activity on the LAN. Since this is a network activity indicator it should only be lit when there's network traffic.
- The WiFi status indicator in the Network settings is wrong, it always displays enabled even if it's not. To see this, go to Network -> WiFi, click on "enable" to make it disabled (greyed out), click Save, the system restarts and it's marked as enabled again. The only way to tell its actual state is via a WiFi scanner to see if the KC868... AP is present or not.
- Time handling is wrong, with the default time zone of UTC the board displays the current time as 17:41 but it's actually 12:41, so it's five hours out. It's also not possible to set all time zones, it stops at UTC+12 but there are countries which are currently at UTC+13. A better way to handle this would be to allow for DST, since UTC+13 is actually UTC+12 + DST offset of 1 hour. Without this, it's necessary to manually change the time on the board every time a DST changeover occurs.