KinCony controller to Mushroom farm

[intelligsystems]

Hi everyone,
I'm new to this forum and new to ESP/Home Assistant.
I have a mushroom cultivation tent where I use a humidifier, blower motors, LED lights, sensors, and an electric heater.
Currently, I control the climate using WiFi-connected sensors, but I would like to fully automate all devices and manage them using Home Assistant (I already have a server and WiFi infrastructure set up).
I'm unsure which Kincony controller would be the best choice, so I’d appreciate your advice. I've attached a diagram showing the devices I want to connect to the controller.

List of devices and required functions in Home Assistant:

• Electric Heater (PTC 1.5 kW): Turn on/off based on the temperature sensor.
  
• Humidity, Temperature, and CO2 Sensor: Read and monitor sensor data.
  
• UV Lamp (in humidifier water container): Activate for short intervals (e.g., every 10 seconds).
  
• Blower Motor: Adjust fan speed based on CO2 sensor readings.
  
• LED Lights: Run for 12 hours daily with adjustable intensity.
  
• Humidifier: Turn on/off based on the humidity sensor.
  

Thanks in advance for your help!
Krzysztof

[admin]

i suggest you chose kincony F16 controller, here is details: https://www.kincony.com/esp32-s3-tuya-re...d-16a.html
you can connect to your loads directly.it use by high quality 16A removable relay. the temperature humidity sensor chose KinCony TS. CO2 sensor use by 4-20mA or 0-5v signal type.

[intelligsystems]

i suggest you chose kincony F16 controller, here is details: https://www.kincony.com/esp32-s3-tuya-re...d-16a.html
you can connect to your loads directly.it use by high quality 16A removable relay. the temperature humidity sensor chose KinCony TS. CO2 sensor use by 4-20mA or 0-5v signal type.

Thank you for your help! I bought the F16 controller. I will test my project, and I hope to share my results with you soon.

[admin]

thanks.