"KCS" v2.2.10 firmware BIN file download

[кшырфе1985]

Я использую плату K868-A16 но при подключении датчика температуры ds18b20 точность 0,5°С хотя датчик может мерить 0,1°С

[AreaKode]

Is there a version available for the KC868-ATC? Thanks!

[admin]

Is there a version available for the KC868-ATC? Thanks!

no, KC868-ATC only have arduino firmware. Not use by KCS firmware.

[acztassi]

hello!!!
i`m having a problem with this version ..
when using ethernet and i make a simple configuration in IFTTT like:

- WHEN DI1 IN BOTH EDGE ... THEN TOGGLE DO1

and in output menu I setup the DO1 to delay (20 seconds) then the ethernet blocks...
even the RJ45 connector leds turn OFF..

tested in A16 and AIO and both boards have the same problem

i tired to turn off and turn on the board... then it start well but a few time after the problem continues and the ethernet stops again

if I only remove the delay configuration to "hold on".. all restart working fine

[admin]

next week we test it.

[draugen]

Hi (KC868-A6)

Seems like the sensor function has some problems at least when posting to mqtt

I have 2 sensors

• A DS18B20 that seems to have a lot of spurious readings
  
• A DHT22 that seems to sit on one value for a very long time, even if other sensors close by shows temperature variations way above the threshold
  

Other than that it seems like a great product!

[admin]

1. About DHT22, whether update value in KCS monitor webpage?
2. do you integrate to home assistant by ESPHome yaml? or by MQTT?

[draugen]

The DHT22 does not update more frequently on the Monitor page than on mqtt. Looks to me as if the temperature over n time does not increase above thresold, then the new current temperature is used as reference.... ie if the temperature continue too increase slowly the valve is never update on webpage/mqtt.  If temperature change quickly it seems to work

The spurious readings on ds18b20 is hard to catch on monitor page soo not 100% sure if that also occurs on Monitor page.

Currently I have set the KC868 to connect to a mosuitto server directly (mqtt). Have no automations running here now, but have a simple node-red dashboard to visualise the readings from the mqtt server.

[admin]

yes, you can test with mqtt broker, monitor the mqtt state topic. maybe you can record a video send to us by google driver or whatsapp number: +86-15381188302

[draugen]

yes, you can test with mqtt broker, monitor the mqtt state topic. maybe you can record a video send to us by google driver or whatsapp number: +86-15381188302

Logfile

about 12 hours log, seems to be better than normal though. Still static readings for the DHT22 and some spurious on the DS18B20.