[Arduino demo source code for KC868-A4]-11 how to create wifi connection

[KinCony Support]

Code:

#include <WiFi.h>
void setup(){
  WiFi.begin("SSID", "PASSWORD");
  // SSID and password is the router you want to connect
  while (WiFi.status() != WL_CONNECTED) {
    delay(500);
    Serial.print(".");
  }
  Serial.begin(9600);
}

void loop(){
  Serial.println("Local IP:");
  Serial.println(WiFi.localIP());
  delay(1000);
}

       

[masoos]

Hello,I have a problem.....wrecked my A4 board with this code.....

I uploaded this code (while I forgot to change the SSID / Password) and the code was uploaded fine by COM10.Then suddenly COM10 disconnected.

Its stays disconnected. Windows does not show COM10 anymore.
I press Reset...voila...com10 connects...
BUT if I release the Reset button, COM disconnects.

I rebooted windows...no difference :-) 
IDE only detects board, while I press reset button (but during this I cannot reflash code)
If I release reset...board is gone

---

Hello,I have a problem.....wrecked my A4 board with this code.....

I uploaded this code (while I forgot to change the SSID / Password) and the code was uploaded fine by COM10.Then suddenly COM10 disconnected.

Its stays disconnected. Windows does not show COM10 anymore.
I press Reset...voila...com10 connects...
BUT if I release the Reset button, COM disconnects.

I rebooted windows...no difference :-) 
IDE only detects board, while I press reset button (but during this I cannot reflash code)
If I release reset...board is gone

I found solution.

open other code and flash again....in the "connecting ........." info wait till 80% progress is made and then release reset button. If you are happy with the timing, the new code starts flashing before windows is closing COM Port

[admin]

if you are using KC868-A4 , actually you not need to use "download" button, it can auto download. just make sure your have stable dc12v for the board.

[masoos]

if you are using KC868-A4 , actually you not need to use "download" button, it can auto download. just make sure your have stable dc12v for the board.

Hello,

I still encounter the problem, that the board is only recognozed by my USB when I hold the reset button. when I release reset, I hear windows sound and the USB disconnects. I searched for this problem and I found that other encountered similar problems with other boards. https://forum.arduino.cc/t/arduinos-only...sed/305602....

I think this has something to do with the RTS signal. There I see a difference with or without reset

Any idea how I can fix this?

I have latest USB drivers
The board shows a stable 5V and 3,3V signal on the oscilloscope.

Thanks, 
M

[admin]

can you change a USB cable for a test.

[masoos]

can you change a USB cable for a test.

did, no effect

---

can you change a USB cable for a test.

did, no effect

It only works, if I connect Pin 14 on the CH340 (RTS) to GND....the USB is connected. 
What is nomal level on RTS without Reset? Is it Low or high?. I have a high (3,16V) 

Thanks

[admin]

tomorrow we check.

[masoos]

tomorrow we check.

I'm sorry, Problem was fault power supply. now with more stable source it works! Thanks

[admin]

ok, i have told you , use a stable DC12v power supply.