KC868-D8

[Dm81]

Hello
I have a question about KC868-D8 in server mode
Is it correct that I don't receive command if I close any digital input on the board?
I think that a client connected to the KC868-D8 should be receive a command (or string) about output variation
thank you

[admin]

if KC868-D8 work in "MQTT", the digital input close, then KC868-D8 should be receive a command (or string) about output variation by payload.
if KC868-D8 work in "TCP Server", will not auto update when digital input close.

[Dm81]

if KC868-D8 work in "MQTT", the digital input close, then KC868-D8 should be receive a command (or string) about output variation by payload.
if KC868-D8 work in "TCP Server", will not auto update when digital input close.

I think is not correct but thank you in any case

[admin]

need read state manual send command.

[Dm81]

need read state manual send command.

sorry for my late reply
I can't ask the output state continuously, It should be the server that send to client every status chang of analog output like for other server (CLOB,H32B...etc..) otherwise I can't monitoring the system
thank you

[admin]

do you using MQTT with KC868-D8?

[Dm81]

do you using MQTT with KC868-D8?

no, KC868-D8 is in server mode and I use it with tcp command

[admin]

you can send read state command for every 500ms. D8 when dimmer brightness changed , only auto feedback to MQTT.

[Dm81]

you can send read state command for every 500ms. D8 when dimmer brightness changed , only auto feedback to MQTT.

if no way to get auto report no problem, but I continue to don't understand the why others device in server mode works correctly and this device no
thank you very much for you support

[admin]

because we mainly update it for MQTT.