KC868 H32 - help - needed firmware

[Kam5]

OK, you can send me the video, we will check. the new firmware include the bootloader function. so when you power on ,begin 5 seconds, there is wait for bootloader, after 5 seconds controller will begin to work. when you update the new firmware of MCU, next time, you can update firmware by RS232 port , not need to use ST-Link cable again.

Dear Admin I sent for You link for video on private message email.


When should be ready new firmware with bootloader for my PLC ?

Thank You.

[admin]

hello, we have not received your email, you can send again, these days in China are new year holidays, when we begin work, we will have a look.

[Kam5]

hello, we have not received your email, you can send again, these days in China are new year holidays, when we begin work, we will have a look.

Dear admin please look at this video

Starting PLC K868 H32

I saw that is the problem when I turn off supply on short time for example ~ 1 min brake and powered on - then PLC not activated earlier powered outputs and I couldn't activate mannually outputs.

I must disconnect power supply only for PLC ( others modules are powered) and powered on - in this case start working correctly as You see on video.

--- New remarks 

After long time - few hours of unpowered (PLC , extended board , RS232 duplicator) - and powered again - PLC start working normally. Is is a problem with short unpowered break.

[KinCony Support]

can you control the KC868-h32 controller by mobile phone??
Let's check it step by step.


no.1

[Kam5]

can you control the KC868-h32 controller by mobile phone??
Let's check it step by step.


no.1

Dear Admin I couldn't check yet because I don't have LAN connection. I must prepare wifi router to check that's the communication. In this week I try to do and confirm.

[Chabeda]

i have an elite qubo digital and i also want to know if its upgradable or not, on the side there is a yellow sticker with firmware 80, wk 49-14 written on it. The serial number may be CQ2381 but i am not sure

Thank you for you answer

[admin]

i have an elite qubo digital and i also want to know if its upgradable or not, on the side there is a yellow sticker with firmware 80, wk 49-14 written on it. The serial number may be CQ2381 but i am not sure

Thank you for you answer

H32L not need to update firmware.

[matej.radek@seznam.cz]

Dear Admin please send the latest firmware for my KC868 H32 PLC.
I have an old version of the 32 Channel Expansion Terminal Light Curtain Wall Switch Panel Board that doesn't work. Do I have to buy a new version and do I need to upgrade the firmware?

Please send for my email matej.radek@seznam.cz

Thank You.

[admin]

ok, i see, now firmware is sent to your email.

[Kam5]

OK, you can send me the video, we will check. the new firmware include the bootloader function. so when you power on ,begin 5 seconds, there is wait for bootloader, after 5 seconds controller will begin to work. when you update the new firmware of MCU, next time, you can update firmware by RS232 port , not need to use ST-Link cable again.

Dear Admin for my KC868-H32 firmware what You send to me is with bootloader or not yet ? We wait for new relase ?

I notice few times freezing communication by new button switch module under normal working - when I pressed quickly few times wall swith - plc or button switch board stop working - I couldn't switch on/off anything
I notice few times abnormal working wall switch connected to input on button switch - when I press wall switch for example 1st room to on and 2nd time to off - on other room switch on the light  . It not show on each time but randomly = but always in this same room light on. I checking connections and should be okay.