ESP32 RF

[Mandlap]

I'm new to the ESP flashing. trying to follow instructions on this thread, flashing the ESP chip to receive RF output on the Arduino without success. Getting the attached error messages. I noticed that i don't have the option to reduce the baud rate lower than 115200.

[admin]

what you want to do? use by "KCS" firmware? or use by home assistant? or ???

[Mandlap]

what you want to do? use by "KCS" firmware? or use by home assistant? or ???

Use with Home Assistant to capture RF signal for TV etc. and control thereafter.

[admin]

you can use ESPHome, just config IR receiver or RF reciever gpio pin. make sure your product have IR or RF hardware function.

[Mandlap]

you can use ESPHome, just config IR receiver or RF reciever gpio pin. make sure your product have IR or RF hardware function.

How do I make sure that the KC868-Server has IR or RF hardware function?

I have tried different configs using different pins (22, 36) in each instant. this is for Samsung TV.

Here is config 1 below for ESPHome:

captive_portal:

remote_receiver:
  pin: 36
  dump: all
  # Settings to optimize recognition of RF devices
  tolerance: 50%
  filter: 250us
  idle: 4ms
  buffer_size: 2kb

Here is config 2 below for ESPHome:

captive_portal:


web_server:
  port: 80

remote_receiver:
  pin:
    number: 23
    inverted: True
  dump: all


remote_transmitter:
  pin:
    number: 22
  carrier_duty_percent: 50%

switch:
  - platform: template
    name: "TV Power"
    turn_on_action:
      - remote_transmitter.transmit_nec:
          address: 0x00BD
          command: 0x807F
          repeat:
            times: 10
            wait_time: 50ms
    turn_off_action:
      - remote_transmitter.transmit_nec:
          address: 0x00BD
          command: 0x807F
          repeat:
            times: 10
            wait_time: 50ms

[admin]

this is GPIOs for KC868-Server's ESP32 module:

IR receiver: GPIO22
IR sender: GPIO23
433MHz wireless receiver: GPIO13

here is details: https://www.kincony.com/forum/showthread.php?tid=1735

[Mandlap]

this is GPIOs for KC868-Server's ESP32 module:

IR receiver: GPIO22
IR sender: GPIO23
433MHz wireless receiver: GPIO13

here is details: https://www.kincony.com/forum/showthread.php?tid=1735

Kindly share the .yaml

[admin]

about the IR and RF you can see our other KC868-A series board, have demo yaml file on our forum.

[Mandlap]

about the IR and RF you can see our other KC868-A series board, have demo yaml file on our forum.

I'm sorted. Thank You.

[admin]

you are welcome.