Smart Home Automation Forum › Technical Support › "KCS" firmware system v
TC100 sensor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
TC100 sensor
philippe Offline
Junior Member
**
Posts: 26
Threads: 8
Joined: Oct 2021
Reputation: 0
#1
06-14-2023, 08:43 PM (This post was last modified: 06-14-2023, 08:44 PM by philippe.)
Hello,
I want to connect a TC 100 sensor on an analog port. How to caliber the result to get the right temperature (instead of value like "650")?
I am using KCS.
Thanks
Find
Reply
admin Offline
Administrator
*******
Posts: 6,339
Threads: 811
Joined: Oct 2020
Reputation: 156
#2
06-14-2023, 10:45 PM
do you have TC100 PDF datasheet file? what's signal output?
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply
philippe Offline
Junior Member
**
Posts: 26
Threads: 8
Joined: Oct 2021
Reputation: 0
#3
06-16-2023, 07:37 AM
Here is the doc.thanks


Attached Files
.pdf   DocTechniqueTC100.pdf (Size: 67.69 KB / Downloads: 291)
Find
Reply
admin Offline
Administrator
*******
Posts: 6,339
Threads: 811
Joined: Oct 2020
Reputation: 156
#4
06-16-2023, 11:17 PM
because our board input range is dc 0-5v, i see your pdf have showed 3 voltage with temperature. i am not sure when your sensor 0-5v means whtat temperature range. you can test, if really hard to use, just replace with DS18B20 is easy to use. we will release new "KCS" V2 soon.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)