+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: "KCS" v2 firmware system (https://www.kincony.com/forum/forumdisplay.php?fid=40)
+--- Thread: "KCS" v2.2.14 firmware BIN file download (/showthread.php?tid=8267)
Pages:
1
2
RE: "KCS" v2.2.14 firmware BIN file download - admin - 11-05-2025
can you take a photo.
RE: "KCS" v2.2.14 firmware BIN file download - acztassi - 11-07-2025
The DAC was in value 0, and last MQTTT Json was also 0,
I changed the DAC via monitor page and no MQTTT was sent.
After 4 minutes another sensor (ADC) was changed and sent the MQTTT with right value.
First problem is this: on change the DAC value a MQTTT message should be sent at right time.
because the messages are being send only when another IO change.
now I send a MQTTT message to set 100%
If you observe the monitor page got the value 100% but didn't refresh the slider position.
And also didn't send a MQTTT message back as confirmation, like occurs in other IOs
RE: "KCS" v2.2.14 firmware BIN file download - admin - 11-07-2025
mqtt payload DAC range is 0--255
KCS monitor webpage, range is 0--100%
so you need to convert data.
RE: "KCS" v2.2.14 firmware BIN file download - acztassi - 11-07-2025
Yes! As I did.
It’s needed to check MQTTT fire event when DAC is changed (either via MQTTT or other way)… and monitor page that when DAC is changed by an external command it does not update de slide bar correctly
RE: "KCS" v2.2.14 firmware BIN file download - admin - 11-08-2025
please take a video of your problem, send to whatsapp number: +86-15381188302