Smart Home Automation Forum
RC snubber wiring - Printable Version

+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-HxB series Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=2)
+--- Thread: RC snubber wiring (/showthread.php?tid=1572)

Pages: 1 2

RC snubber wiring - bigramon - 12-30-2021

Can you please confirm the following wiring of the RC snubber with a KC868-H32B for a furnace valve is OK ?
[Image: kincony-rc-snubber.jpg]

RE: RC snubber wiring - admin - 12-30-2021

what's your valve work voltage?

RE: RC snubber wiring - bigramon - 12-31-2021

(12-30-2021, 11:33 PM)admin Wrote: what's your valve work voltage?

230V AC 50Hz

RE: RC snubber wiring - admin - 12-31-2021

RC snubber connect with valve's coin two point. Parallel with blue and purple wires

RE: RC snubber wiring - bigramon - 12-31-2021

(12-31-2021, 07:50 AM)admin Wrote: RC snubber connect with valve's coin two point. Parallel with blue and purple wires
Like this then ?
[Image: kincony-rc-snubber-3.jpg]

RE: RC snubber wiring - admin - 01-01-2022

correct. But your photo i think not show wholely? right line not deleted?

RE: RC snubber wiring - bigramon - 01-01-2022

(01-01-2022, 02:38 AM)admin Wrote: correct. But your photo i think not show wholely? right line not deleted?
sorry, I don't understand. What right line ?

RE: RC snubber wiring - admin - 01-01-2022

your diagram is right.

RE: RC snubber wiring - bigramon - 01-06-2022

(01-01-2022, 05:59 AM)admin Wrote: your diagram is right.

The RC snubbers did not solve my issue: after less than 3 days with the Kincony RC snubbers installed as indicated in the above diagram, I ran into the same problem: the KC868-H32 MQTT stack stops responding for all relays, turning the Kincony device into a useless brick.
[Image: kincony1.jpg][Image: kincony2.jpg]
Please advise.

RE: RC snubber wiring - admin - 01-07-2022

can you take big photo and upload a full diagram how you wire? your photo to smal , not easy to check.