+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-HxB series Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=2)
+--- Thread: MQTT connect but no data (/showthread.php?tid=452)
MQTT connect but no data - papakigr - 08-16-2021
Hello, i see that the COLB is connected to the MQTT broker but i don't receive any data.
When i connect to the local pc software i see that the device working (have data).
What should i do?
RE: MQTT connect but no data - bigramon - 08-16-2021
(08-16-2021, 05:18 PM)papakigr Wrote: Hello, i see that the COLB is connected to the MQTT broker but i don't receive any data.
When i connect to the local pc software i see that the device working (have data).
What should i do?
Hi,
Use MQTT explorer to debug the messages and get a better idea of what is going on.
Messages are published under relay32.
Good luck!
RE: MQTT connect but no data - admin - 08-16-2021
you should enable the "AutoReport" function in PC software firstly, then MQTT will have message auto upload.
RE: MQTT connect but no data - papakigr - 08-24-2021
Thanks!
RE: MQTT connect but no data - hentes - 01-01-2022
Did you managed to resolve your issue? I have the same situation. COLB send only data for digital sensors, not for temperature and analog sensors. Autoreport is turned on and after COLB restart sends data for a single time, then nothing (only digital sensor values).
RE: MQTT connect but no data - admin - 01-01-2022
do you have set the threshold value firstly?
RE: MQTT connect but no data - hentes - 01-03-2022
(01-01-2022, 02:01 PM)admin Wrote: do you have set the threshold value firstly?
That was the problem. Now it's working like a charm. Thank you.
Did you succeeded to add 1 phase power meter reading with mqtt on COLB device?
RE: MQTT connect but no data - admin - 01-03-2022
use Node-Red can read energy meter and feedback to home assistant.
RE: MQTT connect but no data - hentes - 01-04-2022
(01-03-2022, 12:50 PM)admin Wrote: use Node-Red can read energy meter and feedback to home assistant.
Do you have a link to this flow? I'm not really a Node-Red expert
RE: MQTT connect but no data - admin - 01-04-2022
it's not easy. need to write code. i think you can chose some wifi energy meter so that support MQTT directly.