+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: "KCS" v3 firmware system (https://www.kincony.com/forum/forumdisplay.php?fid=74)
+--- Forum: "KCS" v3 firmware (https://www.kincony.com/forum/forumdisplay.php?fid=75)
+--- Thread: "KCS" v3.15.0 firmware BIN file download (/showthread.php?tid=8687)
"KCS" v3.15.0 firmware BIN file download - admin - 10-28-2025
v3.15.0 improvement:
1. Adaptation for N10 / N20 / N30 AC energy meter board.
2. learned IR/RF signal, will auto create switch button can send out signal and synchronization with Home Assistant
3. DS18B20 support multiple sensors configured on the same GPIO
4. Increase the number of IFTTT IF and THEN conditions from 6 to 12
5. Fixed issue where multiple toggles of DO1 on AIO could cause incorrect control
6. Fixed issue where Zigbee pairing information was not written to flash in time, causing data loss
7. Removed Zigbee beep option from AIO
firmware download:
RE: "KCS" v3.15.0 firmware BIN file download - mrteaiot - 11-14-2025
I am trying to flash the KCS_A8V3_V3.15.0.bin firmware to my Kincony KC868-A8-V1.5 board. It flash but does not boot up. What did I do wrong? I flashed with KCS_KC868_A8_V2.2.14.bin it works but limited features.
Can this board flash with the latest KCS_A8V3_V3.15.0.bin firmware?
Does this board compatible? The board power light up but the Wired Internet RJ-45 no lights up. AP no available too.
RE: "KCS" v3.15.0 firmware BIN file download - admin - 11-14-2025
KCS v3 only use for A8v3 new pcb.
RE: "KCS" v3.15.0 firmware BIN file download - mrteaiot - 11-15-2025
So what latest KCS software firmware I can use to program my Kincony KC868-A8-V1.5 board?
RE: "KCS" v3.15.0 firmware BIN file download - admin - 11-15-2025
https://www.kincony.com/forum/showthread.php?tid=8267