Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't connect using KCS firmware
#1
I just purchased KC868-A6V3 Board.
On connecting the unit I tried connecting using wifi hotspot.
I did not find the hotspot I was expecting instead a "Hidden network" appeared in Wifi network list.
I was unable to connect to this 
I thought that perhaps unit had shipped unconfigured as I purchased from Aliexpress.
I then tried flashing using KCS_A6V3__v3.19.0 firmware but got the same result.
Firmware tool indicated successful installation.
I then tried setting up using ESPhome in HA using your supplied YAML file and that worked OK , unit comes online  , relays are able to be used.
I tried again using KCS firmware but still same result and Hidden network appeared again in Wifi list.
I tried connecting using SSID of ALR-0070077FE024 and passkey supplied in ESPhome YAML file which got me to the message "unable to connect to this network"
I then went back to ESPhome configuration and it works again and appears online , relays work
This proves that the hardware works but I really want to use the Lora functionality to control some water controllers I have.
Also the LCD display has never displayed anything , - why
Any assistance you can supply is much appreciated
Reply
#2
after you downloaded KCS v3 firmware, whether re power on the board?
Reply
#3
(Yesterday, 11:41 AM)admin Wrote: after you downloaded KCS v3 firmware, whether re power on the board?

Yes I did power off and on
Reply
#4
I should have mentioned I get the following output from the serial port when KCS firmware installed.
I followed your installation instructions exactly.

I got the result shown in attached picture

I get this info from serial
rst:0x10 (RTCWDT_RTC_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
ets Jul 29 2019 12:21:46

Regards
       
Reply
#5
take photo of full screen.
Reply
#6
OK , just flashed again and get this result
I powered board off then on , In wifi settings I get "Hidden Network" and for a short while also "OnlyLans" which disappeared soon after


Attached Files Image(s)
   
Reply
#7
Further info. The Hidden Network and OnlyLans networks are not coming from the KC868 as they appear even when KC868 not switched on. My apologies I thought they were .
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)