M30 Power Factor

[Gyro]

dear Admin,

using M30 on 240 VAC I get Power factor values outside the range (0-100), for example 190 or 3000

I use the ARM firmware: M30_V10_241107Res249Unsign.bin
here's the config:
    platform: modbus_controller
    modbus_controller_id: modbus_hub_m30
    address: 1166
    register_type: holding
    name: pf1
    id: m30_1_pf
    accuracy_decimals: 1
    value_type: U_DWORD_R
    filters:
      - multiply: 0.000011921

[admin]

how about you read by RS485 modbus. the RAW value. if this data also outside the range (0-100). tell me.