05-03-2026, 02:28 PM
I bought a KinCony kc868-a8 for a custom project.
With this I want to control (amongst other things) through SG-Ready a heat pump (ALSAVO Air Source Heat Pump Monoblock - 7kW).
The documentation of the heat pump (https://rjwebshop.dk/upload_dir/shop/Zea...Manual.pdf) explains at page 63 that CN10 and CN30 are designed for SG-Ready. These connections I (think) are needed to be connected separately to the relays on the kc868-a8.
Is that right? Do you have any example on how to do that? I think that simple cable without potential will work.
I searched your videos but couldn’t find any information regarding.
Best regards
Savvas
With this I want to control (amongst other things) through SG-Ready a heat pump (ALSAVO Air Source Heat Pump Monoblock - 7kW).
The documentation of the heat pump (https://rjwebshop.dk/upload_dir/shop/Zea...Manual.pdf) explains at page 63 that CN10 and CN30 are designed for SG-Ready. These connections I (think) are needed to be connected separately to the relays on the kc868-a8.
Is that right? Do you have any example on how to do that? I think that simple cable without potential will work.
I searched your videos but couldn’t find any information regarding.
Best regards
Savvas