Does KCS v3 firmware for KC868-H16S3 support a 'delay' parameter in MQTT SET commands
|
Does KCS v3 firmware for KC868-H16S3 support a 'delay' parameter in MQTT SET commands
|
06-09-2025, 08:13 AM
KCS mqtt protocol not support delay time. you can set the auto off time in KCS webpage -- OUTPUT, set the OUTPUT work as a "delay" mode. so that every time, when relay is ON, will auto off after x seconds.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com Alibaba Store: https://kincony.en.alibaba.com/ |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Does KCS v3 firmware for KC868-H16S3 support a 'delay' parameter in MQTT SET commands - by itzek - 06-09-2025, 06:21 AM
RE: Does KCS v3 firmware for KC868-H16S3 support a 'delay' parameter in MQTT SET commands - by admin - 06-09-2025, 08:13 AM
|
| Users browsing this thread: |
| 1 Guest(s) |
