v3.15.0 improvement:
1. Adaptation for N10 / N20 / N30 AC energy meter board.
2. learned IR/RF signal, will auto create switch button can send out signal and synchronization with Home Assistant
3. DS18B20 support multiple sensors configured on the same GPIO
4. Increase the number of IFTTT IF and THEN conditions from 6 to 12
5. Fixed issue where multiple toggles of DO1 on AIO could cause incorrect control
6. Fixed issue where Zigbee pairing information was not written to flash in time, causing data loss
7. Removed Zigbee beep option from AIO
firmware download:
1. Adaptation for N10 / N20 / N30 AC energy meter board.
2. learned IR/RF signal, will auto create switch button can send out signal and synchronization with Home Assistant
3. DS18B20 support multiple sensors configured on the same GPIO
4. Increase the number of IFTTT IF and THEN conditions from 6 to 12
5. Fixed issue where multiple toggles of DO1 on AIO could cause incorrect control
6. Fixed issue where Zigbee pairing information was not written to flash in time, causing data loss
7. Removed Zigbee beep option from AIO
firmware download:
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/