11-07-2025, 09:29 AM
The DAC was in value 0, and last MQTTT Json was also 0,
I changed the DAC via monitor page and no MQTTT was sent.
After 4 minutes another sensor (ADC) was changed and sent the MQTTT with right value.
First problem is this: on change the DAC value a MQTTT message should be sent at right time.
because the messages are being send only when another IO change.
now I send a MQTTT message to set 100%
If you observe the monitor page got the value 100% but didn't refresh the slider position.
And also didn't send a MQTTT message back as confirmation, like occurs in other IOs
I changed the DAC via monitor page and no MQTTT was sent.
After 4 minutes another sensor (ADC) was changed and sent the MQTTT with right value.
First problem is this: on change the DAC value a MQTTT message should be sent at right time.
because the messages are being send only when another IO change.
now I send a MQTTT message to set 100%
If you observe the monitor page got the value 100% but didn't refresh the slider position.
And also didn't send a MQTTT message back as confirmation, like occurs in other IOs