Kincony A-128 – Digital Output LEDs glowing when OFF + module freezes when switching

[krzemodam2]

I use 2x MeanWell 150W 24V with redundancy module and DUPS with 2x 14Ah 12V AGM battery I keep around 23.9V.

I use ESP Home.
Below the beginning of logs:

Code:

INFO ESPHome 2025.5.2
INFO Reading configuration /config/esphome/esphome-web-de9eb8.yaml...
WARNING GPIO5 is a strapping PIN and should only be used for I/O with care.
Attaching external pullup/down resistors to strapping pins can cause unexpected failures.
See https://esphome.io/guides/faq.html#why-am-i-getting-a-warning-about-strapping-pins
WARNING GPIO15 is a strapping PIN and should only be used for I/O with care.
Attaching external pullup/down resistors to strapping pins can cause unexpected failures.
See https://esphome.io/guides/faq.html#why-am-i-getting-a-warning-about-strapping-pins
INFO Starting log output from 192.168.100.70 using esphome API
INFO Successfully connected to kc868-a128 @ 192.168.100.70 in 0.002s
INFO Successful handshake with kc868-a128 @ 192.168.100.70 in 0.048s
[22:02:01][I][app:115]: ESPHome version 2025.5.2 compiled on Nov 29 2025, 21:40:44
[22:02:01][C][logger:224]: Logger:
[22:02:01][C][logger:225]:  Max Level: DEBUG
[22:02:01][C][logger:226]:  Initial Level: DEBUG
[22:02:01][C][logger:228]:  Log Baud Rate: 115200
[22:02:01][C][logger:229]:  Hardware UART: UART0
[22:02:01][C][logger:233]:  Task Log Buffer Size: 768
[22:02:01][C][i2c.arduino:071]: I2C Bus:
[22:02:01][C][i2c.arduino:072]:  SDA Pin: GPIO5
[22:02:01][C][i2c.arduino:073]:  SCL Pin: GPIO16
[22:02:01][C][i2c.arduino:074]:  Frequency: 400000 Hz
[22:02:01][C][i2c.arduino:086]:  Recovery: bus successfully recovered