Smart Home Automation Forum › Technical Support › KC868-A6v3
Can't connect using KCS firmware

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Can't connect using KCS firmware
dalora Offline
Junior Member
**
Posts: 7
Threads: 1
Joined: Feb 2026
Reputation: 0
#4
02-16-2026, 02:15 AM
I should have mentioned I get the following output from the serial port when KCS firmware installed.
I followed your installation instructions exactly.

I got the result shown in attached picture

I get this info from serial
rst:0x10 (RTCWDT_RTC_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
invalid header: 0x6564616f
ets Jul 29 2019 12:21:46

Regards
       
Find
Reply


Messages In This Thread
Can't connect using KCS firmware - by dalora - 02-15-2026, 09:30 AM
RE: Can't connect using KCS firmware - by admin - 02-15-2026, 11:41 AM
RE: Can't connect using KCS firmware - by dalora - 02-15-2026, 12:06 PM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 02:15 AM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 02:24 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 02:44 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 04:41 AM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 11:45 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 08:47 PM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 11:12 PM
RE: Can't connect using KCS firmware - by dalora - Yesterday, 09:45 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)