Smart Home Automation Forum › Technical Support › KC868-A6v3
Can't connect using KCS firmware

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Can't connect using KCS firmware
admin Offline
Administrator
*******
Posts: 9,514
Threads: 1,276
Joined: Oct 2020
Reputation: 244
#12
Today, 03:19 AM
if you want to use OLED display, you need to write your own arduino code or config by ESPHome.
onlye KCS v3 have these new function. But need use by KC868-A6v3 new board.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/
Find
Reply


Messages In This Thread
Can't connect using KCS firmware - by dalora - 02-15-2026, 09:30 AM
RE: Can't connect using KCS firmware - by admin - 02-15-2026, 11:41 AM
RE: Can't connect using KCS firmware - by dalora - 02-15-2026, 12:06 PM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 02:15 AM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 02:24 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 02:44 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 04:41 AM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 11:45 AM
RE: Can't connect using KCS firmware - by dalora - 02-16-2026, 08:47 PM
RE: Can't connect using KCS firmware - by admin - 02-16-2026, 11:12 PM
RE: Can't connect using KCS firmware - by dalora - Yesterday, 09:45 AM
RE: Can't connect using KCS firmware - by admin - Today, 03:19 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)