02-23-2026, 04:29 PM
Hi!
After studying my alarm's manual, I think I can get the outputs I need for what I want to do, but I'm not sure if your Kincony can do it.
I can configure the CH output for full arming using a normally closed (NC) contact and some resistors, so when the contact opens with the relay, the alarm will arm.
I can configure the OUT1 output to indicate that the alarm is armed when there's a negative voltage at that output. When there's high impedance, it indicates that the alarm is at rest.
I can configure the OUT2 output to indicate that the system is OK when there's a negative voltage at that output, or to indicate that the alarm has been triggered when there's no negative voltage at that output but there is high impedance.
Could you please tell me if this wiring is possible with the KC868-A2, for example, and where the connections should go according to the attached diagram?
Thank you in advance!
After studying my alarm's manual, I think I can get the outputs I need for what I want to do, but I'm not sure if your Kincony can do it.
I can configure the CH output for full arming using a normally closed (NC) contact and some resistors, so when the contact opens with the relay, the alarm will arm.
I can configure the OUT1 output to indicate that the alarm is armed when there's a negative voltage at that output. When there's high impedance, it indicates that the alarm is at rest.
I can configure the OUT2 output to indicate that the system is OK when there's a negative voltage at that output, or to indicate that the alarm has been triggered when there's no negative voltage at that output but there is high impedance.
Could you please tell me if this wiring is possible with the KC868-A2, for example, and where the connections should go according to the attached diagram?
Thank you in advance!