03-15-2026, 03:48 PM
My Monitor 1 shows Power=0 for all channels even if there is current which is wrong.
Monitor 2 shows values correctly.
Voltage / Freq 226V, 50Hz is shown on both inputs (both connect to the same phase)
Protocol -> Energy has the same values for Energy 1 and 2 for all of the values of Current Factor=0.5, Power Factor=1, Energy Factor=1
Firmware v3.22.0
What might be the Problem?
Is there no OTA-Update available? Do I need to connect a via USB PC to Update the Firmware?
Monitor 2 shows values correctly.
Voltage / Freq 226V, 50Hz is shown on both inputs (both connect to the same phase)
Protocol -> Energy has the same values for Energy 1 and 2 for all of the values of Current Factor=0.5, Power Factor=1, Energy Factor=1
Firmware v3.22.0
What might be the Problem?
Is there no OTA-Update available? Do I need to connect a via USB PC to Update the Firmware?