Smart Home Automation Forum › Technical Support › KC868-HxB series Smart Controller v
RC snubber wiring

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
RC snubber wiring
bigramon Offline
Junior Member
**
Posts: 18
Threads: 4
Joined: Aug 2021
Reputation: 0
#9
01-06-2022, 06:04 PM
(01-01-2022, 05:59 AM)admin Wrote: your diagram is right.

The RC snubbers did not solve my issue: after less than 3 days with the Kincony RC snubbers installed as indicated in the above diagram, I ran into the same problem: the KC868-H32 MQTT stack stops responding for all relays, turning the Kincony device into a useless brick.
[Image: kincony1.jpg][Image: kincony2.jpg]
Please advise.
Find
Reply


Messages In This Thread
RC snubber wiring - by bigramon - 12-30-2021, 07:19 PM
RE: RC snubber wiring - by admin - 12-30-2021, 11:33 PM
RE: RC snubber wiring - by bigramon - 12-31-2021, 06:49 AM
RE: RC snubber wiring - by admin - 12-31-2021, 07:50 AM
RE: RC snubber wiring - by bigramon - 12-31-2021, 08:50 AM
RE: RC snubber wiring - by admin - 01-01-2022, 02:38 AM
RE: RC snubber wiring - by bigramon - 01-01-2022, 05:48 AM
RE: RC snubber wiring - by admin - 01-01-2022, 05:59 AM
RE: RC snubber wiring - by bigramon - 01-06-2022, 06:04 PM
RE: RC snubber wiring - by admin - 01-07-2022, 12:14 AM
RE: RC snubber wiring - by bigramon - 01-07-2022, 05:35 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)