E16V3 - baudrate change

[ldebacker]

Hello,

Is there a way to change the default RS485 baudrate (which is 38400 bps) ?

Any existing register to change the RS485 parameters ?

Thanks in advance !

[admin]

how to change baud rate:
step1: modbus 06 command write address 2 (data:0-4 0：4800，1：9600，2：19200，3：38400，4：57600)
step2: modbus 05 command write address 501 = true will save the config.
step3: power off->on of board.

if forget the setting. hold on the "RESET" button > 3 seconds, it will auto set to default setting with 38400bps.

[ldebacker]

Many thanks for your reply.

I will try the procedure.

As a suggestion, I think it would be good to include the tip in the instructions manual.

Best regards,

Laurent

[admin]

thanks for your suggestion. we already have updated modbus protocol document.