N60 N30 N20 N10 ARM CPU firmware V20_260324SP

[pvana]

Hi, should I wait for any idea for a solution?   No power value in W is displayed in Energy Monitor 2. The mains voltage is displayed. The current is displayed.

The power factor is calculated internally separately for each measuring coil ?

Thanks Pavel

[admin]

can you read by PC software via USB-RS485 adapter, whether have power value for Monitor2.
here is PC software link: https://www.kincony.com/forum/showthread.php?tid=9326

[pvana]

can you read by PC software via USB-RS485 adapter, whether have power value for Monitor2.
here is PC software link: https://www.kincony.com/forum/showthread.php?tid=9326

Hi, CHIP2 (CH3, CH4, CH5) isn't displaying any values. Any ideas on what to do about this?

[admin]

your photo CH3,CH4,CH5 all have data.
do you means CHIP4,CHIP5,CHIP6? you are using N30, so only chip1,chip2,chip3 have data. every chip manager 10 channel CT.

[pvana]

your photo CH3,CH4,CH5 all have data.
do you means CHIP4,CHIP5,CHIP6? you are using N30, so only chip1,chip2,chip3 have data. every chip manager 10 channel CT.

Hi, not all the data is there. 

Address:200  Check IRMS_CH1, IRMS_CH2, and IRMS_CH3—those are OK—but WATT_CH1, WATT_CH2, and WATT_CH3 have no values.

[pvana]

Hi, I need your opinion on whether I received an N30 with defective BL0910s. Or am I doing something wrong? Alternatively, do you have any ARM CPU firmware I should try? I’ve tried just about everything, and it seems to me that the device is behaving erratically. For example, right now at 1.035 A, it shows 21.8 W at 235 V, while another meter shows 221.2 W.

[admin]

take a photo screen of your "SysParamModify" page of PC software. i want to see what "coefficient" you are setting. We strongly recommend using Kincony's CT sensor. If using a third-party CT sensor, it requires accurate manual configuration of various parameters, which is quite complex.