HI

I recently made a device with KC868-H32b that allows me to communicate with HA. It works as expected, 

and I am able to send and reserve messages to and from the KC868-H32b.

The issue I am facing is that when the KC868-H32b is unplugged from power  


HA remembers the last known state the KC868-H32b was in, rather than updating the front end to show that the device has 

gone offline.


So, Is it possible to publish custom topic on kc868-h32b?

For example. 

payload_available and payload_not_available 

Thank you

I have been using the MultiBoard Control interface for KC868-ColB and H32L.  It provides a very nice display of status of all relays and inputs.  However, the six digital inputs to the relay controller (-H32L) are not included.  (Also not included in KBox-Pad).  Is it possible to add these to the MultiBoard panel for KC868-H32L?

IOT application and practice of smart home engineering book published in China. This book have wrote for 2 years. There are some smart home application case and IOT development resource for smart control system. The book we wrote in Chinese words.

here is download tool for ESP32 or ESP8266: https://www.espressif.com/en/support/dow...ther-tools
router firmware:
  esp32_nat_router-master.zip (Size: 692.46 KB / Downloads: 1324)
set 3 file address:
0x1000
0x10000
0x8000

  dashboard raw code.txt (Size: 32.83 KB / Downloads: 1005)
  automations.zip (Size: 1.08 KB / Downloads: 1174)
  binary_sensor.zip (Size: 748 bytes / Downloads: 1164)
  configuration.zip (Size: 744 bytes / Downloads: 1148)
  light.zip (Size: 745 bytes / Downloads: 1174)
  node red dimmer flow 2021 10 15.zip (Size: 3.38 KB / Downloads: 1149)
  Nodered heating flow.zip (Size: 2.03 KB / Downloads: 1100)
  Nodred Switch flow.zip (Size: 3.04 KB / Downloads: 1198)
  sensors.zip (Size: 1.49 KB / Downloads: 1171)
  switch.zip (Size: 1.76 KB / Downloads: 1125)
  temperaturos ESP home.zip (Size: 823 bytes / Downloads: 1181)

   
dear admin

I need some help. please explain how do you place a "AND" statement "OR" statement in the Kincony Controller Application as attached?

My example would be:-

1. Run the pump (Relay 32) for 2min AND if Water Float is empty shutoff pump (Relay 32)

I can find the "AND" statement "OR" statement on the application.

Thank you

Regards
Subas

https://www.kincony.com/download/KC868-H...ommand.pdf

You applied free sample KC868-A8 have sent by FedEx, tracking number is 990293794752.
Hope your project goes well and share everyone your achievements.

improvement:
fixed bug sometimes can't save the setting after reboot.

download the ZIP file , unzip update the bin file for KC868-H32BS relay controller by USB-RS232 cable.


  H32BS_V139_211010.zip (Size: 51.11 KB / Downloads: 1141)
firmware update tool download: https://www.kincony.com/download/KC868-C...loader.zip