Is it possible to add logic controllers besides adding Terminal Switch to KC868-H32BS  in one board ?

Hello,

i connected on KC868-COLB normal radars with NC output and through MQTT are reported to Home Assistant.

The problem is that when there is no movement is showing like ON (like detected movement) and when there is motion shows OFF (not detected movement).

How can i invert it, either on COLB or on Home assistant, in order to be OFF when there is no motion and ON where there is motion?

hi 
Do you have virtual training programs?

With it, I can practice on your software

SORRY DID  KC868'S CONTROLER AUTOMATICALLY SWITCH BETWEEN OPTION  WHEN NO INTERNET MEANING IF NO INTERNET  IT ADJUST TO LAN AUTOMATICALLY

Step1: chose your network device of your computer.
Step2: click "StartMonitorPort" button.
Step3: click "SCAN" button.
Now all KinCony Controller (KC868-HxB or KC868-HxBS) will be see.

download link: https://www.kincony.com/download/KinCony...Device.zip

Hello
Do you have a way to automate administrative offices and meeting rooms ?
So that in the case of people, the lighting and air conditioning devices are turned on, and when people leave the administrative offices, all loads are stopped?

Hello, i see that the COLB is connected to the MQTT broker but i don't receive any data.

When i connect to the local pc software i see that the device working (have data).

What should i do?

Hi,



I just received my H32B, upgraded to version 4.35 and configured it as follows (I only use wired Ethernet):

   

Unfortunately, the H32B does not connect to my Mosquitto MQTT broker although the MQTT Explorer running on my computer does, using the same credentials.

I tried to reset the configuration using the Ethernet mode button but it did not help.



Did I miss something in the configuration ?

Night update - it finally connected to the Mosquitto addon, without any additional action from my side.
I could set up all relays and inputs and restarted the KC868 to check whether it would re-establish the MQTT connection.
It actually did but after several minutes.

I then restarted the Mosquitto addon but this time the KC868 did NOT reconnect.
I waited for another 15 minutes and then power cycled the KC868.
But even after 10 minutes, it still did not connect to the MQTT broker.

It looks like the MQTT connection still needs work to become more reliable.

This flow use RS485 Modbus work with KC868-H32BS. Demo functions have:
Read 6 digital input sensor state,
Read 32 MOSFET output state,
turn ON/OFF output-1
turn ON/OFF multi-output ports by one command.

  KC868-H32BS-Node-Red-Modbus-flows.zip (Size: 1.59 KB / Downloads: 1085)

https://www.kincony.com/download/KC868-H...Modbus.pdf