[arduino source code for KC868-Uair-7] send IR code signal

[admin]

#include "PinDefinitionsAndMore.h"
#include <IRremote.h>

void setup() {

  Serial.begin(9600);
  IrSender.begin(IR_SEND_PIN, ENABLE_LED_FEEDBACK);

}

  uint16_t sAddress = 0x78;
  uint8_t sCommand = 0xCD;
  uint8_t sRepeats = 0;

void loop() {
  IrSender.sendNEC(sAddress, sCommand, sRepeats);
  delay(1000);
}


download arduino IDE source code file: 

  Uair_IR_send.zip (Size: 388 bytes / Downloads: 296)

Note: install "IRremote" library online firstly.



set IR sender and receiver GPIO pins define as below image: