KinCony KC868-HAv2 not getting config setting

[ia1]

Dears

I am unable to get config setting in hav2 module while clicking read once button connected through usb to rs 485 converter, but when i connect any input to gnd it send some information as attache pictures

[admin]

when HAv2 board power on , whether have RED led blink? that's running led .

[ia1]

when power on its blink fast fr few seconds and than blink slow after wards, I have two HAV2,both are doing same.

---

thanks dear for your support, I found issue with USB-RS485 convertor

[admin]

yes, it's normal.

[spaemice]

I also have a problem, during restart/power failure when the system boots up it doesn't give me feedback from the module, whether it is on or not until I make some change on/off I get the initial result: binary_sensor 1 Unknown ??

[admin]

we will update this in furture, just update ESPHome component for HAv2.