KC868-A8 Switch

[glorifiedg]

Hi!
I purchased some KC868-A8 to install in my new home and I'm now testing them. 

I flashed one with ESPHome but the switches don't change relay state unless I program an automation in Home Assistant to do that (if input1 on/off change alternate relay state). Is it there anyway to configure this without HA? Should I use another firmware for this?

I also like to know if there any other device that can work with dimmable leds.

[admin]

1. you can download KCS v2 firmware , then config IFTTT let INPUT toggle OUTPUT. here is online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
2. if you want use dimmer LED, you can chose KC868-D16 dimmer controller or KC868-AP dimmer controller.