KC868-ap

[Gerrit]

Hello, 
I received the board recently and was able to get it working with esphome.  I am using this board to connect ledstrips with a voltage of 24v. 
Ik have also some downlights at 12v that I would like control with the board. I see that the powerrail is divided in 3 sections but connected to eachother. Would it be possible to separate one part and connect the 12v downlights with a 12v powersupply? If not what could be another solution.

[admin]

sure, KC868-AP support DC12-24v. if you want to use DC12v led strip, just power supply use by DC12v is ok.

[Gerrit]

sure, KC868-AP support DC12-24v. if you want to use DC12v led strip, just power supply use by DC12v is ok.

thanks for the answer. But perhaps, I did not explain my question well. What I would like to achive is to use 24v ledstrips and 12v downlights on the same kc868-ap board.  I see that all the supplies are tight together on the circuit board.

[admin]

no, can't use 24v and 12v different type of LED strip with one AP board at the same time. only chose one of voltage to use.