I connected temperature sensor. But the relay doesn't work

[harryduck]

Hi
I connected a DS18B20 temperature sensor. and bind with output1. 
I configured if temperature higher than 20'c then output 1 goes high, if temperature lower than 19'c then output1 goes low.
But output1 doesn't move. What I have to do in this situation?

[admin]

which board you are using?
what firmware you are using?
what setting you have config?
if you want ask one question, please tell us details.

[harryduck]

which board you are using?
what firmware you are using?
what setting you have config?
if you want ask one question, please tell us details.

I'm using KC868-A8M controller and KCS V2 firmware.
I set if temperature higher than 20'c, then fan rotated by output 1 relay.
 But it doesn't work when temperature higher than 20'c.
(output 1 relay bound with temperature sensor)
I attached picture below

Thank you!

[admin]

cancel the pop window, i can't see your "IF" setting.

[harryduck]

cancel the pop window, i can't see your "IF" setting.

[admin]

take a photo of your "SENSOR" setting screen.

[harryduck]

take a photo of your "SENSOR" setting screen.

[admin]

Temperature Threshold set to 0.5
Humidity Threshold set to 1
for a testing

[harryduck]

Temperature Threshold set to 0.5
Humidity Threshold set to 1
for a testing

It's working!! I really appreciate your help!
Have a nice day ^^

[admin]

ok, good.