"KCS" firmware Modbus protocol document

[admin]

Note: This protocol document use for KinCony ESP32 smart controller:
KC868-A4 KC868-A6  KC868-A8 KC868-A8S KC868-A16 KC868-E16S KC868-A32 KC868-A64 KC868-A128 smart controller
Different board will have different channel of digital output, digital input , ADC, DAC, so the protocol is same , just according to the hardware resource to set channel number.

  KC868-A-series-protocol-ModBus.pdf (Size: 139.11 KB / Downloads: 1,712)

[abgran]

How to read sensor in channel 1? Not a ADC. There is no in the documentation.

[admin]

read sensor by RS485 modbus protocol? or MQTT?
which board model you are using?

[abgran]

read sensor by RS485 modbus protocol? or MQTT?
which board model you are using?

by RS485. My board KC868-A6.

[admin]

modbus not support read sensor by 1-wire port.
if you can write arduino code, you can define protocol by yourself.

[abgran]

modbus not support read sensor by 1-wire port.
if you can write arduino code, you can define protocol by yourself.

i see. okay. understand that. no problem for that. solved. just want to know why the sensor not state in the documentation.

Thank you.